Keylocking threaded insert KLTI-M12-175-SS

KNM12X1,75 Keenserts lightweight metric type

M12x1,75 metric coarse internal thread (non-locking) and M16x1,5 external thread – 303 stainless steel

The thin wall M12x1,75 keylocking insert results in an increased thread strength in low strength materials such as alloys or other light materials. The external thread of this insert is M16x1,5. This insert can also be used in steel and cast iron.

Although these type of inserts are typically used in a production environment, they are also popular as a high quality thread repair solution to replace a damaged thread with the same size thread.

KLTI-M12-175-SS keylocking insert, alternative for KNM12X1,75 Keenserts

partnumber

KLTI-M12-175-SS

Reference partnumber: KNM12X1,75

To request or order this product, please fill in the desired quantity below and press the ‘add to list’ button.

Quantity:

Internal thread

M12 x 1,75
Tolerance: 5H

External thread

M16 x 1,5
Tolerance: 4h
# Keys: 4

Material & finish

Stainless Steel 303 CRES + passivation

Go to our downloads section to get our most recent catalogues.
In these catalogues you will find all the spec sheets with dimensions and drawings.

KLTI-M12-175-SS drawing

drawing of keylocking insert with same dimensions as Keenserts KNM12X1,75

Installation instructions

STEP 1 : Drill & Chamfer

KLTI-DRILL-CHAMFER

Drill a hole in the place where you want to use the insert. Chamfer the edges of the drilled hole.

Drill diameter: 14,75 mm
Drill partnumber: DRM-1475

Chamfer angle: 80° – 100°
Countersink diameter: 16,25 mm

STEP 2 : Tap thread

KLTI-TAP-THREAD

Tap thread inside the drilled hole with the same tread size as the outer thread of the insert.

Thread size: M16 x 1,5
Tolerance: 6H
Minimum depth: 17,5 mm
Tap partnumber: TP-M16-150

STEP 3 : Insert & Drive keys

KLTI-INSERT-DRIVE-KEYS

Install by screwing in the insert, rotating by hand and/or with the installation tool.
Once the insert is completely in place, tap the installation tool with the hammer so the keys are driven inside the outer thread, this accomplishes the locking of the insert in position.

Installation tool partnumber: KLTI-IT-M12

Removal instructions

The insert is removed without any damage to the installation thread and a new (same size) insert can be used again.

STEP 1 : Drill

KLTI-REMOVAL-DRILL

Drill out material between keys and internal thread with a standard drill to specified depth so that the keys become accesible.

Drill diameter: 13,5 mm
Drill partnumber: DRM-1350
Drill depth: 4,75 mm

STEP 2 : Unlock

KLTI-REMOVAL-REMOVE-KEYS

Break off the keys by deflecting them inwards.

STEP 3 : Remove

KLTI-REMOVAL-UNSCREW

Now that the keys are gone the insert is no longer locked in place and it is possible to take out the insert by unscrewing it with an easy out screw extractor.

The insert has now been removed. There is no damage to the installation thread. It is now possible to install a new (same size) insert by continuing with step 3 of the insallation instructions.